Adding a touch of convenience and flexibility to your Tesla Model 3 or Model Y, the Dashboard Touch Screen Swivel Mount Kit allows you to adjust your screen for optimal visibility and accessibility. This installation guide will walk you through the step-by-step process to ensure a successful installation. Before we begin, please make sure you have the necessary tools listed below and carefully read the precautions for a safe and efficient installation.
Product List:
- Plastic pry tool
- Phillips screwdriver
- H5 hex wrench
- H14 hex socket
- 10mm wrench
Installation Precautions: To ensure a safe and proper installation, it is important to follow these precautions:
- Read the instructions carefully to expedite the installation process.
- Use the H14 hexagon socket to adjust the rotation force of the bracket.
- Before installation, check the product list for completeness and any signs of damage.
- Do not attempt to remove any parts yourself, as it may void the warranty.
- Turn off the vehicle power and disconnect the battery negative pole in the frunk.
- read the instructions thoroughly before starting.
- After installation, confirm the correctness of the installation and wiring before testing.
- Ensure the installed product functions properly, checking if all plugs are securely connected.
- Verify the normal functioning of the original vehicle features after installation.
- If you receive a damaged item, do not proceed with the installation. Take immediate photos of all parts and contact the after-sales team for assistance. Claims for damages discovered after installation will not be accepted.
Contact Information: If you require assistance or have any questions, please contact Us:
Email: info@goevparts.ca
Installation Steps:
Step 1: Remove the original car screen
- Gently remove the temperature sensor using a pry bar.
- The trim panel may require multiple attempts with the pry bar to remove it successfully.
- Rotate and remove the temperature sensor.
Step 2: Remove the original car screen
- Use a 10mm open-ended spanner to remove the original vehicle screen.
- Remove the two fixing screws of the original vehicle screen harness.
- Take care while removing the screen to prevent any accidental damage.
Step 3: Remove the original car screen
- Use a T25 box spanner to remove the plastic cover plate of the original vehicle.
- Press and pull out the locking clip of the connector.
- Place a sponge pad on the screen, ensuring it prevents sliding and damage during the installation.
Step 4: Install the rotating bracket and the mesh bracket
- Insert the swivel mount kit into the original vehicle bracket hole.
- Secure the bracket with two screws from the original vehicle, tightening them with a 10mm spanner.
- Attach the protective cover on one side of the bracket and rotate the bracket on the other side.
Step 5: Install the rotating bracket and the mesh bracket
- If there is a significant gap, install the snap gasket. If the gap is small, the gasket is not necessary.
- Align the hole position and install the buckle at the corresponding position of the original vehicle.
- Connect the screen of the original vehicle and thread the harness into the protective cover first.
Step 6: Install the rotating bracket and the mesh bracket
- Secure the screen with the original screws.
- Install the screen onto the bracket.
- Fix the screen
Step 7: Install the rotating bracket and the mesh bracket
10. Fix the temperature sensor on the base
11.Sort out the harness and fix the buckle gap cover on the base